How to maintain an aluminum profile cutting machine?
1. Daily need to check whether the aluminum cutting machine oil cup has lubricating oil, our company uses 20# air pressure lubricating oil, should keep seven points full, to avoid air pressure parts without lubricating oil and reduce the service life, check whether the pressure is maintained at a pressure of 6-7kg to operate, the pressure is too large or too small to damage the air pressure parts, the water filter of this machine has the function of automatic water discharge, if you can not automatically drain the water filter device, please replace the water filter device by yourself, to avoid water accumulation in the pipeline, affecting the work of the machine.
2. The fuse switch should be kept off when the power supply is not in use to ensure the safety of the machine and personnel.
3. In the lubrication place, the joint of the struts and the pressing frame ring, the front and rear axles of the connecting rod frame, the cylinder joint and the two ends of the roller in and out of the material, it is necessary to check once a week, and lubricate in a timely manner to avoid the loss of downtime caused by jamming.
4. Cutting oil: This oil injection group can be sprayed with CPC-R32 or saponified oil, the air volume can be adjusted and the left and right oil volume can be controlled separately using aluminum alloy cutting oil or water-soluble cutting oil (saponified oil) 1:20, the ratio can not be too thin, to avoid rust or jamming caused by too heavy water, it is necessary to check whether the oil amount is sufficient every day, and it needs to be replenished when it is insufficient, and sufficient cooling can increase the life of the tool and reduce the burr of aluminum cutting.
5. Keeping the work surface clean can ensure the precision of sawing.
6. Check whether the air duct is damaged every day, and replace it with a new air duct if it is damaged, so as to avoid the machine not working normally due to water leakage.
7. The oil drum uses CPC-R68 hydraulic oil, which needs to be kept full for seven minutes to ensure that the cylinder moves smoothly, first remove the back cover of the air source OFF when refueling, open the oil cover above the oil drum, add the oil to seven points full, close the oil cover, if the back cover can be on.
8. Regularly (preferably once a week) to check whether the belt is excessively worn, whether it is parallel, and whether the pressure on the surface of the belt is too loose or too tight.
9. If the pneumatic parts are faulty or inactive during operation, please replace the faulty pneumatic parts.
10. The oil injection cooling system of this machine uses an injector, which uses the siphon principle to suck the cooling oil to the nozzle and cool the saw blade, so as to avoid the failure of the air compressor parts and debris
