Oct 20, 2025 Leave a message

Several Methods to Improve the Yield of Aluminum Extrusion Products

How to improve the yield of extrusion products? Here are some suggestions for extrusion operators and quality inspectors to consider:

 

1) Quality Inspection: Machine quality inspection should adopt a fast, accurate, and strict approach. 'Fast' means inspecting diligently and promptly; 'accurate' means being familiar with national standards, internal control standards, and the standards for different customers and surface treatments. When necessary, samples should be taken for corresponding surface treatment tests, and misjudgment or acceptance of substandard products must be avoided. In special cases where judgment cannot be made, the relevant responsible person should be reported immediately; 'strict' means maintaining a firm stance and enforcing the system rigorously.

 

2) Extrusion Team Leader: Must not use the wrong mold or fill out the tracking card incorrectly. Should actively perform self-inspection, first inspection, and process inspection work.

 

3) Main Machine Operato: Should actively cooperate with the team leader, verify each set of molds, control the three temperatures, flexibly manage the material flow according to different model structures and surface treatments, monitor the material quality at any time, and be responsible for wall thickness, forming quality, tearing or inner dragging issues, and accurately calculate whether the offcuts of semi-finished profiles after sawing different specifications are long enough.

 

4) Interruption Worker: The interruption worker is also a very important position. If a quality issue is discovered, it must be reported to the team leader or acting team leader immediately. For each set of molds that go on the machine, the height of the outlet lift frame, the graphite blocks, and the high-temperature rollers must be checked because they directly affect the formation of the output material. The fan should be turned on promptly, and the conveyor belt's operation should be checked to ensure it is smooth and effective. If bubbles, oil bubbles, or tearing are found on the profile surface, clear markings must be made on the profile to prevent it from entering the next process.

 

5) Straightening Worker (Material Mixing, Cutting to Size, Frame Assembly):

 

Before straightening each material, the surface quality must be thoroughly inspected. Profiles should not be piled too high on the cooling bed to avoid abrasion or damage. Hollow profiles should use appropriate plugs to prevent breakage and excessive deformation. If there are assembly relationships, the actual matching should be based on the sample of the corresponding surface treatment model from the current batch order, which will then be used to control the straightening stretch rate.

 

When combining materials, pay attention to the fact that materials with different surface treatments have different methods of combining. For raw materials, oxidized sandblasted materials, and "oxidized electrophoretic glossy materials," try to keep the non-decorative surface facing down or have the non-decorative surfaces face each other, maintaining a gap between the profiles as much as possible to avoid scratching, bumping, scraping, or damaging the decorative surfaces.

 

Before cutting to a fixed length, it is necessary to consider whether the head and tail waste of the material are long enough. If it is found that the entire piece of material or the batch is not long enough, the operator should be notified immediately to stop or start the machine. After cutting, carefully check whether the ends of the profiles are deformed. If deformation occurs due to cutting, the cutting speed can be appropriately slowed down.

 

Before installing the insulation material into the frame, each piece must pass the platform inspection. For profiles with more complex shapes that are easily damaged by spacers after framing, each layer should be separated with flat tubes. Products with strict surface quality requirements must be spaced individually with high-temperature felt, and the placement of spacers must be neat.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry