Jul 15, 2025 Leave a message

The generation and avoidance of oil marks and watermark defects on the surface of aluminum profiles

The generation and avoidance of oil marks and watermark defects on the surface of aluminum profiles--

The characteristics of oil marks on the surface of aluminum profiles reflect:

The oil stains of the aluminum profile are not wiped clean before aging, and a watermark is generated on the surface of the aluminum after aging, and it is dark spots and has a certain depth after oxidation.

Causes of oil marks on the surface of aluminum profiles:

1. The finished sawing oil stains are left at both ends of the aluminum profile, and the gloves are not clean or even sticky with graphite ash when moving (lifting) the material;

2. When the aluminum profile is stretched, the gloves are dirty and the material is too long, and the sawing is not removed;

3. The gloves are dirty and leave a "mark" when sorting the materials in the middle;

4. Extrusion equipment tools leakage oil stains (driving, hoisting belt).

Elimination method of oil marks on the surface of aluminum profiles:

1. In the process of aluminum production, http://www.aps.com.cn/ the gloves should be clean when lifting and moving, and the gloves should be wiped off in time if there are oil stains;

2. When stretching aluminum, the material should be appropriate;

3. Handle the materials, the gloves when lifting and carrying the materials and the gloves when stretching and taking the materials, and the gloves when adding the rods should be separated;

4. Pay attention to oil leakage of equipment and tools, and clean paper, cushion strips, slings, etc.

 

The characteristics of the watermark on the surface of the aluminum profile reflect:
Silver-gray wet marks appear on the surface of the aluminum profile, and the aluminum alloy profile decreases or disappears with the increase of the strength of oxide alkali washing.

Causes of watermark on the surface of aluminum profile:
The surface of the aluminum profile is partially stained with water and rain, and the fine pores of the oxide layer on the surface of the profile penetrate into the aluminum matrix to form trihydroxyaluminite, which is bright and light with the length of water retention time, and if there are impurities (salt, nitrite acid, etc.) in the water, corrosion spots will occur.

 

Watermark elimination method on the surface of aluminum profile:
The water-stained aluminum profile should be wiped dry as soon as possible, and must be wiped dry before aging, and the alkali sin time and oxide film thickness should be increased appropriately if the conditions are sufficient. 

Send Inquiry

whatsapp

Phone

E-mail

Inquiry